Patient monitor User’s manual
Chapter 3-9
1. Select 【 Module Set 】 smartkey to enter the Module config window in
which you can select the Temp label you want to alter. Then, there is a
module config window popping up.
2. Select 【Module Set】to rename the temp. Options are as follows:
Nasopharyngeal
temperature
1. Select【Module Set】smartkey to enter the Module config window in which
you can select the IBP label you want to alter. Then, there is a module config
2. Select【Change Label】to rename the IBP. Options are as follows:
Pulmonary artery pressure
3.10.3 Resolving Label Conflicts
Each label must be unique, that is, it can only be assigned once. You
can’t monitor two pressures labeled “Tskin” at the same time. If you need to
use two identical temperatures, you must assign different labels to them.
Measurement labels are stored in the measurement module. If you try to use
two measurement modules with identical labels, the monitor will close the
second module automatically.
Take the Temp module for example, when your monitor has been equipped
To Next Page
