NOTICE
In Follow Mode, you will need to adapt how the camera follows your movements.
With the Deadband value, you can define the amount of delay between your movement of the
MAXIMA and the reaction of the camera.
!
NOTICE!
A higher value will produce a higher delay.
With the Expo Curve you can define the amount of Ramp after the camera picks up your
movement.
NOTICE!
A higher value will produce more ramp.
By changing the speed value you can increase or decrease the speed of the single axis in the
follow mode.!
NOTICE
Lowering the value will increase the delay and increase the difference between the camera
from your movement.
For example:
NOTICE
These values are suitable for a camera setup with 10 Kg / 22lb.
If the camera is heavier the Expo Curve value must be increased and Speed values must be
reduced.
!
To Next Page
Loading...
