ARRI TRINITY - Follow Mode vs. Fully Stabilized; Mode Selection for Different Setups; Switching Axes Between Modes

!
13.0 Follow Mode or Fully Stabilized
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
If you want to change one of the axes into Follow Mode or back to Fully Stabilized, you have
to toggle the ON/OFF switch to single axis.
For example:
If you want to switch on the Follow Mode for the Tilt axis, then position the switch to „ON“.
Or if you want to have the Tilt axis in fully stabilized mode, then position the switch to „OFF“.
37
Follow Mode
Handheld
Easy Rig
artemis Arm & Vest
Fully Stabilized
Handheld
Hard Mounted
Crane & Trinity