ARRI TRINITY - Restore Sensors; Restore Settings to Factory Default

!
15.1 Restore Sensors
If the TRINITY is hard to control or not holding its position, !
it may help to reset the sensors.
• Press the OK key!
• Press the DOWN key four times till Restore!
• Press the DOWN key till Sensors
• Press the OK key “Sensors“!
• Press the UP key one time “ Yes “
• Press the OK key
15.2 Restore Settings
If you want to bring all setting to the factory setup follow
the steps below.!
• Press the OK key!
• Press the DOWN key four times till Restore
• Press the OK key “Settings“!
• Press the UP key one time “ Yes “
• Press the OK key
40
1. Joystick!
2. Remote!
3. Calibration!
4. Remote Pairing!
5. Restore!
6. Info
7. Exit
1. Joystick!
2. Remote!
3. Calibration!
4. Remote Pairing!
5. Restore!
6. Info
7. Exit