CYC5000 User Guide www.arrow.com
Page | 33 March 2023
5.1.15 Click “Finish”.
5.2 Building a Blinky Project with CYC5000
Overview: In this section you will create the components to a design, make connections, set the
pins, and compile a project. The goal is to go through the design process of a simple blinky project,
where the toggle speed of the LEDs could be controlled by one of the pushbuttons of the
CYC5000.
5.2.1 Block Diagram
The final system that will be built with the following steps will look as follows when complete:
To Next Page
Loading...