Arrow CYC5000 - Installing Arrow USB Programmer2

CYC5000 User Guide www.arrow.com
Page | 25 March 2023
4.1.6 Finish the installation of the Quartus Lite and proceeded to the next section to install
Arrow USB Programmer2 to be able to connect to the CYC5000 board.
4.2 Installing Arrow USB Programmer2
The CYC5000 board uses version 2 of the Arrow USB Programmer2 programming solution, that
is an FTDI FT2232H Hi-Speed USB controller plus a programmer DLL. Since this FTDI USB
controller is a very common standard device, usually no specific drivers are needed to make the
CYC5000 work.
4.2.1 Download the appropriate version
1
of Arrow USB Programmer2 for CYC5000 from
Trenz Electronic Wiki page or alternatively this direct link.
1
Modules produced after June 2020 are no longer compatible with older drivers. Please install driver version
2.4 or newer.