CYC5000 User Guide www.arrow.com
Page | 65 March 2023
6.2.2.3 Go to <project_directory>/ and open output_file.jic.
If you do not find the programming file, it may be that the default save location is
<project_directory>/output_files/ so check that folder as well.
When you add the .jic file, the Programmer will automatically update the JTAG chain and
put the configuration flash memory.
6.2.2.4 Make sure the Programmer shows the correct file and correct parts in the JTAG chain.
Check the Program/Configure checkbox.
To Next Page
Loading...