Access Levels
and
Supervisor Tasks 6
Steps to Upload a User Database
To upload a
of
user and
perform the
following
I. Create an ASCII text file called "users.ree" that the user
identifications, passwords, and access levels. should be
separated by
a
comma
only (no spaces). Example:
USERNAME1,PASSWORD1,ACCESS-LEVEL 1
USERNAME2,PASSWORD2,ACCESS-LEVEL2
USERNAME3,PASSWORD3,ACCESS-LEVEL3
where:
•
USERNAME
must alpha-numeric, no more than 10
•
PASSWORD
must be alpha-numeric, no more than 10 characters
•
ACCESS-LEVEL
must be either
1,2
(1=Operator, 2 = Supervisor)
2. From a PC
Microsoft~
Windows, open the command prompt
application (emulation
of
an MS-DOS® shell).
3. Type:
cd
<path>
where <path> is the pathname to the
users.ree
file.
4.
Determine the sterilizer's IP """,,,v.N
to
the Network Settings
screen).
5.
Transfer userS.ree file to the sterilizer by typing:
TFTP
<sterilizer
IP
address>
PUT
users.ree
where <sterilizer
IP
address> is the address obtained from the Network
Settings screen.
6.
On
the touch the
Upload
User
Data
The information
in the file will be displayed with the password concealed "*,,
characters.
You will
"""",
.. ,,,, an "INVALID
NX
DATABASE FILE"
message
if
the password
or
user name is longer than the permissible
length,
you
have specified an invalid access level,
or
you have used an
invalid
7. the
Confirm
button to accept displayed data,
current user and return
to
the prior screen.
STERRAO®
N)('"
Users Guide
61
To Next Page
Loading...
