Maintenance 8
Chapter
8.
Maintenance
4 Note: Repairs and adjustments should only
be
attempted
PY''lor'ior.ron
technicians who are fully trained to
maintain and the STERRAD®
NX
ThI
Sterilizer.
Use
of
unauthorized parts
for
maintenance or
could cause personal injury, result in costlyaa,maJ!,e,
or malfunction and voids the
"'''''''',?>11''
Automatic Maintenance
Some maintenance procedures are performed automatically
by
the sterilizer
software. The user does not have to any to start an automatic
maintenance procedure. are two automatic maintenance
controlled
by
the software, they are:
• Pressure
• Automatic Lamp
Pressure Zeroing
Periodically, the sterilizer will need to adjust the pressure transducers to
ensure that they are operating within the
When operator presses the Toucb Screen to
Start
screen, and
if
the
sterilizer
is
within two days
of
its automatic pressure zeroing function, a
"Pressure Recommended" message will be displayed,
notirying the that the function should be run.
If
a
Pressure Zeroing procedure
by
the operator within
the required time interval, a "Pressure Zeroing Required" warning message
will be displayed on System screen.
If
this occurs, the operator
will
be
unable to start a cycle. A will
be
required to successfully
perform the Pressure Zeroing procedure.
STERRAO@
NX'" User's Guide
79
To Next Page
Loading...
