ASP sterrad NX - Diagnostic Messages

9Troubleshooting
System Message Probable Cause
Suggested Remedy
UNABLE TO LIGHT
The plasma did not light during
Run diagnostics. Call your ASP
PLASMA. USE EXTRA canceled cycle.
Customer Care Representative.
CAUTION WHEN
HANDLING THIS LOAD.
UNABLE TO OPEN ONE
A bad
or missing PCMCIA
Call your ASP Customer Care
SECOND DATA FILE
compact flash memory. Representative.
VACUUM TIMEOUT The time needed to evacuate the Run diagnostics. Call your ASP
chamber has expired. Customer Care Representative.
VENTING PLEASE
The chamber
is venting until it None required.
WAIT ...
reaches atmospheric pressure.
W
ARMlNG UP, PLEASE
The sterilizer
is warming up.
None required.
WAlT ...
Diagnostic Messages
If an error occurs during operation, the sterilizer may allow you to run a
diagnostic test immediately. When prompted to do so, touch the
Confirm
button to perform the diagnostic test. A diagnostic test displays and prints a
diagnostic message when the test
is completed. Some diagnostic messages
indicate conditions that you may be able to remedy.
4Note: If a diagnostic message is not found in the following
table, there
is no remedy available that you may
safely perform. Call the
ASP Customer Care Center
for assistance.
Message
Probable Cause Suggested Remedy
12 VOLT SUPPLY HIGH
12 volt DC supply> 14.4
Call your ASP Customer Care
volts.
Representati ve.
12 VOLT SUPPLY LOW
12 volt DC supply < 9.6
Call your ASP Customer Care
volts.
Representati ve.
15 VOLT SUPPLY HIGH
1 5 volt DC
supply> 18 volts. Call your ASP Customer Care
Representative.
15 VOLT SUPPLY LOW
15 volt DC supply < 12 volts. Call your ASP Customer Care
Representative.
24 VOLT SUPPLY HIGH
24 volt DC
supply> 28.8 Call your ASP Customer Care
volts.
Representative.
24 VOLT SUPPLY LOW
24 volt DC supply
< 19.2 Call your ASP Customer Care
STERRAD~ NX'" User's Guide
94