H202
CURVE AREA
I
TOO LOW
H202
RA TE CONSTANT
TOO HIGH
INJECT
TIMEOUT
INJECT TIMEOUT
MEMORY CARD FULL
PLEASE CLOSE DOOR
PLEASE INSERT NEW
CASSETTE
PLEASE OPEN DOOR
POWER FAIL
CANCELLATION
POWER SUPPLY OUT
OF RANGE
PRESSURE OUT OF
RANGE (Low)
SYSTEM FAILURE -
CALL ASP.
SYSTEM PROBLEM -
CALL ASP!
Probable Cause
The calculated H
2
0
2
area under
the time-temperature curve
is
less than the threshold value set
in the CCF.
The calculated rate constant for
is
greater than
threshold value set
in
the CCF.
The time needed to initialize the
into the
chamber has expired.
More than 50 records are
contained on PCMCIA card.
The next cycle record will
(""'.'!"U/nT"
the oldest cycle
record.
The door was opened while the
system was wanning up.
No cassette was detected.
Displayed cycle
completion. The load
is
ready
for removaL
A power failure occurred during
a cycle.
A power supply
is
20%
higher
or
lower than specified.
There
is
a pressure problem
i with the vacuum system.
A error has occurred.
A system error has occurred.
Troubleshooting
Suggested Remedy
Run diagnostics. Call your ASP
Customer Care Representative.
Run Call your ASP
Customer Care Representative.
Run diagnostics. Call your ASP
Customer Care
Store record infonnation
from PCMCIA card on an
external PC.
Close the door.
Insert a valid cassette.
Open the door.
Call your ASP Customer Care
Representative.
Run
nl~lcrnf\"'tll''''
Run Call your
ASP Customer Care
Representati ve.
Call your ASP Customer Care
STERRAOil!>
NX"' User's Guide 93.
To Next Page
Loading...
