ASTEC RT360 User Manual

LUBRICATION
AU103170 H5B 58
Hydraulic Return Filter
Change the return line filter every 200 hours of operation
or if the warning lamp for the return filter illuminates.
NOTE:
It is recommended that you change the hydraulic
suction filter when you change the hydraulic return filter.
See Suction Filter in this manual.
A18949
1. RETURN FILTER
To change the hydraulic filter follow these steps:
1. Turn the hydraulic return filter (1) counterclockwise
and remove the filter. Discard the filter.
2. Apply a thin layer of clean grease or engine oil to the
O-ring of the new filter.
IMPORTANT:
DO NOT use a filter strap wrench to
tighten the filter. A strap wrench can cause a leak if the
filter is dented.
3. Install the new filter. Use your hands to tighten
filter 1/3 turn after the filter makes contact with the
filter head.
4. Start the engine and run the engine at idle for
approximately 1 minute.
NOTE:
You must be seated in the operators seat to start
the engine.
5. Stop the engine and remove the key. Check for leaks.
6. Check the hydraulic reservoir fluid level.
Suction Filter
Change the suction filter every 200 hours of operation or
if the warning lamp for the filter illuminates.
NOTE:
It is recommended that you change the hydraulic
return filter when you change the hydraulic suction filter.
See Suction Filter in this manual.
PIC00115
1. SUCTION FILTER
To change the suction filter follow these steps:
1. Turn the suction filter (1) counterclockwise and
remove the filter. Discard the filter.
2. Apply a thin layer of clean grease or oil on the O-
ring on the new filter.
IMPORTANT:
DO NOT use a filter strap wrench to
tighten the filter. A strap wrench can cause a leak if the
filter is dented.
3. Install the new filter. Use your hands to tighten the
filter 1/2 turn after the filter makes contact with the
filter head.
4. Start the engine and run the engine at idle for
approximately 1 minute.
NOTE:
You must be seated in the operators seat to start
the engine.
5. Stop the engine and remove the key. Check for leaks.
6. Check the hydraulic reservoir fluid level.
Breather
Clean the breather every 1,000 hours of operation or each
year, whichever occurs first.
A18957
1. BREATHER
WARNING: Replace all covers or guards after
servicing or cleaning the machine. NEVER
operate the machine with covers or guards
removed
1
1
1

ASTEC RT360 Specifications

General

Brand	ASTEC
Model	RT360
Category	Lawn and Garden Equipment
Language	English