SPECIFICATIONS
AU103170 H5B 80
Standard 260 Digging Chain, 2 Pitch, 6” Digging Width (50,000 lb)
Terminator Carbide Assembly
BS99G086
1. ADAPTER - TERMINATOR, RIGHT HAND, CENTER AND 4 INCH CUT
2. ADAPTER - TERMINATOR, LEFT HAND, CENTER AND 4 INCH CUT
3. ADAPTER - TERMINATOR, RIGHT HAND, CENTER AND 5 INCH CUT
4. ADAPTER - TERMINATOR, LEFT HAND, CENTER AND 5 INCH CUT
5. ADAPTER - TERMINATOR, RIGHT HAND, CENTER AND 6 INCH CUT
6. ADAPTER - TERMINATOR, LEFT HAND, CENTER AND 6 INCH CUT
7. SPACER - TUBE, INSIDE MOUNT
8. SPACER - TUBE, OUTSIDE MOUNT
9. BOLT - HEX HEAD 5/8 X 3 INCH CENTER CUT
10. BOLT - HEX HEAD 5/8 X 3-3/4 INCH
11. LOCKNUT -5/8 INCH
NOTE:
Repeat the tooth sequence shown until the chain is complete.
NOTE:
If additional information is needed, see your Astec dealer for part numbers and quantities of items shown when
replacing worn or missing parts.
CENTER CUT
10.16 cm (4 INCH) CUT
12.7 cm (5 INCH) CUT
11
5
9
1
8
CENTER CUT
10.16 cm (4 INCH) CUT
12.7 cm (5 INCH) CUT
15.24 cm (6 INCH) CUT
6
6
7
2
2
10
1
3
15.24 cm (6 INCH) CUT
11
To Next Page
Loading...
Need help?
General
