4
Handling of this instrument (Continued)
◇Do not pass corrosive materials over the prism
or through the sample inlet unit.
◇Cleaning liquids up to 160 ˚C can be used for
CIP or SIP. The momentary difference between
the sample liquid temperature and the cleaning
liquid temperature must be no more than 80 ˚C.
When using cleaning liquids at temperatures
over 160˚C, the power switch must be turned
off.
◇If sample material has collected on the prism,
please refer to Page 48 "13.Cleaning the Prism"
of this manual for cleaning instructions.
◇Turn off the power switch before leaving the unit
out of serviced for an extended period of time.
◇When relocating the unit, pack it fully to guard
against shocks during transit and enclose it in
the corrugated fiberboard box in which it had
been delivered.
◇Carefully read this instruction manual and fully understand the function and operation of each part of the
instrument before use.
◇Inspect each part of the instrument for damage or defects that may have occurred in the shipping or
manufacturing process.
◇Check the necessary operations such as zero setting according to the instruction manual.
◇The manufacturer shall not be liable for any and all damages resulting from uses of the instrument that
deviate from those intended by the manufacturer, which are the measurement of Brix, sugar content, and
concentration of liquid solutions.
◇The prism is a consumable item and is not covered under warranty.
Special care should be taken to avoid scratching or damaging the prism.
◇The manufacturer shall not be liable for any effect the use of this instrument may have on the consumption or
application of the measured materials or related processes, etc.
To Next Page
Loading...
