Answering system
109
Answering system settings
Voice guide to set Answering system
This feature is an alternative way for you to do the basic
setup of the answering system. You can follow the voice
guide to record your own announcement, set the number
of rings, and set the message alert tone.
This feature is only available on the telephone base.
1. When the telephone base is in idle mode, press
MENU/SELECT.
2. Press CID or DIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press CID or DIR to scroll to Voice guide, then press
MENU/SELECT. You hear a voice prompt, “This voice
guide will assist you with the basic setup of your
answering system.“
4. Setup your answering system by inputting designated numbers, as
instructed in the voice guide.
Notes:
You can press CANCEL to quit the voice guide at any time.
If the system does not receive any input, it will play an alert message. If there is still no input, it will announce “Sorry, I
still have not received any input. If you want to restart the voice guide, please enter the menu and select Voice guide under
Answering system. Good bye.”
After a power outage, the system prompts you to set the date and time, and Smart call blocker. After these settings are
done or skipped, the system prompts if you want to set up the answering system via voice guide. Press MENU/SELECT
to start the setup.
Play messages
>Answering sys
Answer ON/OFF
>Voice guide
Setting up
Answering sys...
To Next Page
Loading...
