Multiple handset use
53
Push-to-talk (PTT)
PTT call to a single device
Using a cordless handset:
1. There are a few ways to begin a PTT call to a single device.
When the handset is not in use:
If you have one handset, press and hold PUSH TO TALK.
If you have more than one handset:
w Press PUSH TO TALK on the handset. Then, use the
dialing keys to enter the destination device number.
-OR-
w Press PUSH TO TALK on the handset. Press CID or
DIR to highlight the destination device number, then
press MENU/SELECT or PUSH TO TALK.
The handset shows Connecting to HANDSET X...
(HANDSET represents the handset name, X represents the
destination handset number) or Connecting to BASE 0...
(BASE represents the base name)
for a few seconds. When
the connection is made, both your and the destination
device screens display Press and hold [PTT] to talk.
2. Press and hold PUSH TO TALK. A chirp indicates your
microphone is on. Speak towards the device. Your voice is
broadcast to the destination device.
While you are speaking, your handset shows
PTT To handset: X or PTT To base.
3. Release PUSH TO TALK after speaking. Both devices beep once
again and the screens show Press and hold [PTT] to talk, then, you can
press and hold PUSH TO TALK to continue speaking or the destination
device can respond (see Answer a PTT call on page 56).
4. To end the PTT call, press
OFF/CANCEL or place the cordless handset in
the charger. The handset shows Push to talk Ended for a few seconds.
PUSH TO TALK
>HANDSET X
Connecting to
HANDSET X...
Press and hold
[PTT] to talk
PTT To
handset: X
To Next Page
Loading...
Need help?
General
