31
Telephone settings
Telephone base settings
Set date/time
The answering system announces the day and time of each message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are set
automatically with each incoming call. The year must be set so that the day
of the week can be calculated from the caller ID information. You can turn o
the date and time settings of the caller ID service and set the date and time
manually (see Use caller ID to automatically set date and time on page
36).
Aer a power failure, the system prompts you to set the date and time.
To set the date and time manually:
1. When the telephone base is in idle mode, press
MENU/SELECT to enter the main menu.
2. Press CID or DIR to scroll to Set date/time and
then press MENU/SELECT.
3. Press CID or DIR to choose the month, then press
MENU/SELECT, or enter the number using the
dialing keys.
4. Press CID or DIR to choose the day, then press
MENU/SELECT, or enter the number using the
dialing keys.
5. Press CID or DIR to choose the year, or enter
the number using the dialing keys, then press
MENU/SELECT to move on to set the time.
6. Press CID or DIR to choose the hour, then press MENU/SELECT, or enter
the number using the dialing keys.
7. Press CID or DIR to choose the minute, then press MENU/SELECT, or
enter the number using the dialing keys.
8. Press CID or DIR to highlight AM or PM, or press 2 for AM or 7 for PM.
Then, press MENU/SELECT to conrm. There is a conrmation tone and the
screen returns to the previous menu.
Note: If the clock is not set when a message is recorded, the system announces, “Time and day not set,”
before it plays the message.
SET DATE
MM/DD/YY
Ringers
>Set date/time
SET TIME
HH:MM --
To Next Page
Loading...
Need help?
General
