Answering system
112
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
Using a cordless handset or the telephone base:
1. When the telephone is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press CID or DIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press CID or DIR to scroll to Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting. You hear a
conrmation tone.
REMOTE CODE
19
# of rings
>Remote code
Voice guide
>Ans sys setup
# of rings
>Remote code
Answer ON/OFF
>Ans sys setup
REMOTE CODE
19
To Next Page
Loading...
