Answering system
113
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. By default, the
message alert tone is set to o.
There is no audible alert at the handset.
To change the setting:
Using a cordless handset or the telephone base:
1. When the telephone is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press CID or DIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press CID or DIR to scroll to Msg alert tone, then
press MENU/SELECT.
5. Press CID or DIR to choose On or O.
6. Press MENU/SELECT to save the setting. You hear a
conrmation tone.
Notes:
The message alert tone beeps only if all the following conditions are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
To temporarily turn off the message alert tone, see page 117.
Remote code
>
Msg alert tone
MSG ALERT TONE
>On
Remote code
>
Msg alert tone
MSG ALERT TONE
>On
To Next Page
Loading...
Need help?
General
