Telephone operation
46
Options while on calls
Blind transfer
While on an outside call, you can transfer the call to a specic device or any
device without notifying them.
To transfer an outside call from a handset:
1. During the call, press MENU/SELECT.
2. Press CID or DIR to scroll to Transfer, then press
MENU/SELECT.
If you have one handset and no other registered devices,
the outside call is put on hold and your handset shows
Transferring call.... The telephone base rings and shows
Transfer from HANDSET X.
If you have other registered device(s) or more than one
handset, your screen shows TRANSFER TO:. Use the
dialing keys to enter a specific device number (0 for the
telephone base, 1-9 for handsets 1-9, TONE followed
by 0-2 for handsets 10-12, or TONE followed by # for all
devices), or press CID or DIR to scroll to the desired
device and press MENU/SELECT. The outside call is put
on hold and your handset screen shows Transferring
call... or Transferring call to all.... The other device rings and shows
Transfer from HANDSET X (HANDSET represents the handset name, X
represents the handset number).
3. To answer the call on the destination handset, press
PHONE/FLASH
or /SPEAKER. To answer the call on the telephone base, li the
corded handset or press /SPEAKER. The initiating handset shows
Call transferred and goes to idle mode.
Phone 0:00:12
6:30
AM
8/06
>Equalizer
Transfer
TRANSFER TO:
>HANDSET 2
To Next Page
Loading...
Need help?
General
