Multiple handset use
Handset locator
The handset locator feature is useful if you
misplace any handsets.
To start the paging tone:
Press /FIND HS on the telephone base to
start the paging tone on all handsets for 60
seconds.
Note: If you press
OFF/CANCEL or MUTE/DELETE on a handset,
the ringer of that handset stops, but the paging to the rest of the
handsets continues.
To stop the paging tone:
Press
PHONE/FLASH, /SPEAKER, or any
dialing key (0-9, TONE or #) on the handset(s).
-OR-
Press /FIND HS, MUTE/DELETE or CANCEL on
the telephone base.
Join a call in progress
When a handset or the telephone base is already on a call and you would like
to join the call, press
PHONE/FLASH or /SPEAKER on your handset or
/SPEAKER on your telephone base, or lift the corded handset.
To end the call using a cordless handset, press
OFF/CANCEL or place the
handset in the charger. To end the call using the telephone base, press
/SPEAKER or return the corded handset to the telephone base. The call
does not end until all handsets and the telephone base hang up.
Note: You can use up to four system handsets and the telephone base at the same time on an outside call.
Multiple handset use
48
** Paging **
To Next Page
Loading...
