AT&T DLC-100 User Manual

Testing Your System
Digital Life User Manual | Page 53 of 62 ATT-UM-V1.1-201303
Device Procedure Results Notes
o Open one protected
door or window
o After the alarm has
been observed, enter
your Alarm Panel PIN
to cancel the alarm
and then enter your
Alarm Panel PIN
again to clear the
message
• Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
• Keypad LCD will display:
Alarm Canceled
• Keypad LCD will display:
Enter PIN to Clear
Recessed
Door /Window
Sensor
(SW-ATT-
RDW)
• DLS in Test Mode
End-to-End Testing
• Test each device one at
a time by executing the
following procedure:
o Arm the system in
the Armed-STAY
Mode
o Open one protected
door or window
o After the alarm has
been observed,
enter your Alarm
Panel PIN to cancel
the alarm and then
enter your Alarm
Panel PIN again to
clear the message
End-to-End Testing
• For each device
• Keypad LCD will display:
<Device Name> -
Opened (For example,
“Kitchen Door -
Opened”)
• Keypad LCD will display:
Intrusion Alarm Sent
• Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
• Keypad LCD will display:
Alarm Canceled
• Keypad LCD will display:
Enter PIN to Clear
• An Intrusion alarm
has been sent to
AT&T Digital Life
Central Monitoring
Center with no
action required
Motion Sensor
(SW-ATT-PIR)
• DLS in Test Mode
End-to-End Testing
• For each device
• There is a three (3)
minute delay
between

AT&T DLC-100 Specifications

General

Brand	AT&T
Model	DLC-100
Category	Controller
Language	English