ATEN Room Booking System User Manual
14
Glass Wall: Stick the 2 strips of tape provided to the back of the wall
plate, and then press the wall plate onto the glass wall, with the arrows
on the plate pointing upward.
IMPORTANT:.For optimal adhesive results, make sure to firmly press
the taped mounting plate against the wall for 3 ~ 5 seconds and wait for
it to dry for at least 24 hours.
2. Secure the provided panel plate to the back of the RBS panel using the
short screws provided.Using the 90° RJ-45 cable adapter provided and an
Ethernet cable, connect the RBS panel to a PoE switch / injector to provide
power and access to network.
3. Place the RBS panel onto the wall by sliding and attaching it to the wall
plate.
4. Turn on the RBS panel by switching its power switch to ON.
Upon first-time startup, the VK430 shall be offline and not connected to any
calendar server.
To set up the VK430, you shall use the ATEN RBS Configurator software to
create the necessary setting profiles to be uploaded to it. See RBS Configurator,
page 17.
To Next Page
Loading...