ATEQ F670 - Creation of Test Program; Selection of the Test Type

Sheet #678u – Starting up
Version 1.04a User guide ATEQ 6th series Page 4/4
4. CREATION OF TEST PROGRAM
To access to the parameters menu, from the
cycle menu, press the
or
keys.

Pr 001
LEAK TEST
Then select the
menu
Select a program by using the
keys.
To create a new program, press an empty
program (----------).
Then the test type selection window is
displayed (see following paragraph).
2#4#/'6'45
Copy-Paste
Ź Pr:01 -----------------
Pr:02 -----------------
Pr:03 -----------------
Pr:04 -----------------
Pr:05 -----------------
Pr:06 -----------------
Pr:07 -----------------
4.1. SELECTION OF THE TEST TYPE
Four types of test are available:
The PARAMETERS menu gives access to
four possible tests types :
¾ Leak test (LEAK TEST).
¾ Pressure test (BLOCKAGE).
¾ Test in desensitized mode
(DESENSITIZED TEST).
¾ Operator test (OPERATOR). .
¾ Burst test (BURTS TEST).
¾ Volume measurement (VOLUME).
For the different tests types, see the sheet
#673: "Definition, characteristics and
measurement principles".
2#4#/6;2'
Ź LEAK TEST
BLOCKAGE
DESENSITIZED TEST
OPERATOR