ATEQ F670 - Program Deletion or Program Name Delection

Sheet # 680f – Leak programs parameters
Version 1.04a User guide ATEQ 6th series Page 8/9
3.2. PROGRAM DELETION OR PROGRAM NAME DELETION
This menu allows deleting a program or its name.
To access to the parameters menu, from the
cycle menu, press the
or
keys.

Pr 001
LEAK TEST
Then select the
menu
Select the program to delete by ising the
keys and then validate with
the
key.
2#4#/'6'45
Ź Copy-Paste
Pr:01 LEAK TEST
Pr:02 -----------------
Pr:03 -----------------
Pr:04 -----------------
Pr:05 -----------------
Pr:06 -----------------
Pr:07 -----------------
The program parameters are displayed, select
"TYPE" with the
keys and
validate with the
key.
2#4#/2T
TYPE : LEAK TEST
COUPL A : 0.0 s
FILL TIME : 1.0 s
STAB TIME : 4.0 s
TEST TIME : 2.0 s
DUMP TIME : 0.8 s
Press. UNIT: mbar
Ź Max FILL : 600.0
The delete menu appears, There are two
possibilities: delete the program name or
delete the whole program. Select what to
delete with the
keys and then
validate with
key.
2#4#/

2T6'566;2
Ź Delete name
Reset program
Caution! The program or program name deletion are instantaneous without prior
notice.
Note: if the "Program" deletion operation is done first, then the "Program name" deletion is
done too.