The Service user profile is protected by a password. After selecting the Service user profile, the
following screen pops up:
The user can enter the password by swiping up or down on the right vertical swipebar to select
the first digit.
Tap ‘→’ to be able to enter the second digit.
Once the 4 digits are entered, the user can confirm by tapping ‘V’ or decline by tapping ‘X’.
Language
Starting from the Controller Settings menu, swipe left until the Language screen is shown.
To modify the setting, see section Select or modify a setting.
The controller will reboot after changing this setting.
Units
The units displayed can be modified through this menu.
CAN Settings
The list of CAN Settings is shown. When CAN is turned off, the settings can be modified.
Ethernet Settings
The list of Ethernet Settings is shown. When ethernet is turned off, IP address, Subnet mask and
Gateway can be modified.
Do not forget to turn on ethernet settings after changing these settings. Otherwise the
controller can’t connect anymore!
Display Timeout
Starting from the Controller Settings menu, swipe left until the Display Timeout screen is shown.
Display timeout is used to save energy and save the lifetime of the display. Timer starts after last
operator actions on the push buttons or swipe bars.
Instruction book
2920 7109 51 45
To Next Page
Loading...
