• That IP address will be excluded from the DNS server, so it will be reserved for the
controller.
• Also get the correct Gateway and Subnet mask settings. For example:
• IP = 10.25.43.200
• Gateway = 10.25.42.250
• Subnet mask = 255.255.254.0
• Connect the controller to the company's network (LAN) by using a UTP cable (min. CAT 5e).
• Adapt the network settings in the controller.
• Put the controller in “advanced status”, scroll down to “Controller Settings” and swipe
left to “Ethernet settings”:
• Switch off the ethernet communication to allow editing the settings:
• Adapt IP Address
• Adapt Gateway IP
• Adapt Subnetmask
• Switch on the Ethernet communication
• Wait a few minutes so the controller can be connected to the LAN network
Configuration of the web server
The internal web server is designed and tested for Microsoft
®
Internet Explorer.
Also "Opera", "Mozilla Firefox", "Safari"and "Chrome" should work.
Viewing the controller data
All screen shots are indicative. The number of displayed fields depends on the selected
options.
Instruction book
2920 7109 51 49
To Next Page
Loading...
