ATOMOS strongly recommends that your NINJA V+ is plugged into
mains power before commencing the firmware update. If using bat-
teries for power, ensure that they have plenty of charge and that you
do not interrupt your NINJA V+ while its firmware is upgrading. You will
see a progress bar to the lower half of the screen. When it is finished,
the NINJA V+ will restart and you will be able to use the device as nor-
mal. This process can take up to 5 minutes.
7. Press the Power Button to power the NINJA V+ on. The AtomOS update process will
begin automatically.
If you place the .FW file on the drive and insert it into the NINJA V+
whilst it is turned on, the device will recognize the firmware update and
ask if you’d like to apply the update. If you select 'OK' the device will
shut down and begin the update process. Once the update has com-
pleted, your NINJA V+ will delete the .FW file and power down.
8. If your NINJA V+ is already powered on, you will be prompted to perform the
AtomOS update when a drive containing a new AtomOS version is inserted.
9. The ATOMOS logo will appear. After a few seconds the AtomOS update will start.
10. During the AtomOS update, an ‘updating firmware’ screen will appear. The update
will take a few minutes.
11. When the AtomOS update is finished, the NINJA V+ will:
To Next Page
Loading...
Need help?
General
