MediaPack
Analog Fast Track Guide 20 Document #: LTRT-59805
Figure 3-1: Client Configuration Screen with Blank Parameters
3.1.3 Assigning an IP Address Using the Voice Menu Guidance
¾ To assign an IP address using the voice menu guidance, take these 7
steps:
1. Connect a telephone to one of the FXS ports. Lift the handset and dial ***12345 (three stars
followed by the digits 1, 2, 3, 4, 5).
2. Wait for the 'configuration menu' voice prompt to be played.
3. To change the IP address, press 1 followed by the pound key (#).
• The current IP address of the gateway is played. Press # to change it.
• Dial the new IP address; use the star (*) key instead of dots ("."), e.g. 192*168*0*4 and
press # to finish.
• Review the new IP address, and press 1 to save it.
4. To change the subnet mask, press 2 followed by the # key.
• The current subnet mask of the gateway is played. Press # to change it.
• Dial the new subnet mask; e.g. 255*255*0*0 and press # to finish.
• Review the new subnet mask, and press 1 to save it.
5. To change the default gateway IP address, press 3 followed by the # key.
• The current default gateway address of the gateway is played. Press # to change it.
• Dial the new default gateway address; e.g. 192*168*0*1 and press # to finish.
• Review the new default gateway address, and press 1 to save it.
6. Hang up the handset. Access the gateway's Embedded Web Server with the new IP address
you assigned (refer to Section 3.3 on page 23).
7. Reset the gateway. On the main menu bar, click the Maintenance button; the 'Maintenance
Actions' screen is displayed. From the 'Burn to FLASH' drop-down list, select 'Yes', and then
click the Reset button.
http://ArtTel.ru
To Next Page
Loading...
Need help?
General
