Analog Fast Track Guide 3. Configuring the MediaPack
Version 5.0 29 October 2006
3.4.4 Example of Connecting Two MP-118 Devices
This example applies to H.323 and SIP. Figure 3-6 below shows an example of two MP-118/FXS
devices’ internal routing tables. The phone ‘2001’ is connected to the first channel of gateway
10.2.222.108, and phone ‘2101’ is connected to the first channel of gateway 10.2.222.107.
To make a call between two gateways, lift the receiver of phone ‘2001’; a dial tone is heard and
the first Channel Status LED lights up. Dial 2101; after dialing the last digit phone, ‘2101’ rings.
Note 1: The prefixes you choose in the ‘Tel to IP Routing’ table must differentiate the
gateways from each other to ensure correct routing. In the example, using the
first digit (2) doesn’t differentiate the devices, thus 2 digits of the phone number
are used.
Note 2: To enable phones connected to the same MediaPack to communicate with each
other, define in the internal routing table the IP address and corresponding
phone numbers of the device itself.
Figure 3-6: Example of Connecting Two MP-118 Devices
http://ArtTel.ru
To Next Page
Loading...
