MediaPack
Analog Fast Track Guide 38 Document #: LTRT-59805
Figure 7-7: ‘End Process’ Screen
11. Click the End Process button; the ‘Quick Setup’ screen appears and the full Web application
is reactivated.
7.2 Updating the Auxiliary Files
The auxiliary files are configuration dat files that are loaded to the gateway (in addition to the ini
file) to enable enhanced gateway provisioning. For information on additional auxiliary files, refer
to the MediaPack User’s Manual. Table 7-1 presents a brief description of the ini file and of each
auxiliary file.
Table 7-1: ini and Auxiliary Files Descriptions
File Type Description
ini
Load this file to provision the device’s parameters. The Embedded Web Server
enables practically full device provisioning but customers may occasionally require
new feature configuration parameters in which case this file is loaded.
Note that loading the ini file only provisions parameters that are contained in the ini
file. If a parameter is not specified in the ini file, values associated with that parameter
are reset to a default value. These values may not be the same as the values that
were configured for the VoIP gateway at the time of manufacture.
Note: After the file has completed loading, the VoIP gateway automatically restarts
(software is loaded from the flash).
FXS Coefficient This file contains the telephony interface configuration information for the VoIP
gateway. This information includes telephony interface characteristics, such as DC
and AC impedance, feeding current and ringing voltage. This file is specific to the
type of telephony interface that the VoIP gateway supports. In most cases you have
to load this type of file.
Note: Use the parameter ‘CountryCoefficients‘ (described in the MediaPack User’s
Manual) to configure the FXO coefficients.
Voice Prompts The voice announcement file contains a set of Voice Prompts to be played by the
MediaPack during operation on Call Agent request. Only MGCP is supported.
Call Progress
Tones
This is a region-specific, telephone exchange-dependent file that contains the Call
Progress Tones levels and frequencies that the VoIP gateway uses. Default CPT file:
U.S.A.
http://ArtTel.ru
To Next Page
Loading...
