MediaPack
Analog Fast Track Guide 22 Document #: LTRT-59805
3.2 Restoring Networking Parameters to their Initial State
You can use the ‘Reset’ button to restore the MediaPack networking parameters to their factory
default values (described in Table 3-1) and to reset the username and password.
Note that the MediaPack returns to the software version burned in flash. This process also
restores the MediaPack parameters to their factory settings. Therefore, you must load your
previously backed-up ini file, or the default ini file (received with the software kit) to set them to
their correct values.
¾ To restore the networking parameters of the MP-11x to their initial state,
take these 4 steps:
1. On the MediaPack's rear panel, press the ‘Reset’ button uninterruptedly for a duration of
more than six seconds; the gateway is restored to its factory settings (username: ‘Admin’,
password: ‘Admin’).
2. Assign the MP-11x an IP address (refer to Section 3.1 on page 18).
3. Load your previously backed-up ini file, or the default ini file (received with the software kit).
To load the ini file via the Embedded Web Server, refer to the MediaPack User’s Manual.
4. Press again on the ‘Reset’ button (this time for a short period).
¾ To restore the networking parameters of the MP-124 to their initial state,
take these 6 steps:
1. Disconnect the MP-124 from the power and network cables.
2. Reconnect the power cable; the gateway is powered up. After approximately 45 seconds the
Ready LED turns to green and the Control LED blinks for about 3 seconds.
3. While the Control LED is blinking, press shortly on the reset button (located on the left side
of the front panel); the gateway resets a second time and is restored with factory default
parameters (username: ‘Admin’, password: ‘Admin’).
4. Reconnect the network cable.
5. Assign the MP-124 an IP address (refer to Section 3.1 on page 18).
6. Load your previously backed-up ini file, or the default ini file (received with the software kit).
To load the ini file via the Embedded Web Server, refer to the MediaPack User’s Manual.
http://ArtTel.ru
To Next Page
Loading...
