AUTOFLAME Mk8 MM Installation And Commissioning Guide

3 Water Level Control
04.09.2016 Mk8 MM Expansion Features Installation and Set-Up Guide Page 59
3.8.6 Setting Control Point Level
Figure 3.6.8.i Commission Control Point Level
After storing or updating the 1
st
low level, press to increase the water level to the 1
st
low
level.
Once the water has risen to the required control point level, turn the pump off and close the valve. Let
the readings settle and press . If required, the control point level can be updated by then
adjusting the water level and pressing once the position has been stored.

AUTOFLAME Mk8 MM Specifications

General

Brand	AUTOFLAME
Model	Mk8 MM
Category	Controller
Language	English