AUTOFLAME Mk8 MM Installation And Commissioning Guide

3 Water Level Control
04.09.2016 Mk8 MM Expansion Features Installation and Set-Up Guide Page 57
3.8.4 Setting 2
nd
Low Level
Figure 3.8.4.i Commission 2
nd
Low Level
After storing or updating the end of probe level, press to increase the water level to the
2
nd
low level. It is recommended that there is a 25mm (1”) gap between the commissioned levels, which
is approximately 500Hz.
Once the water has risen to the required 2
nd
low level, turn the pump off and close the valve. Let the
readings settle and press . If required, the 2
nd
low level can be updated by then adjusting
the water level and pressing once the position has been stored.

AUTOFLAME Mk8 MM Specifications

General

Brand	AUTOFLAME
Model	Mk8 MM
Category	Controller
Language	English