Owner Installation Instructions GDO-10V3L2 Toro
™
21
20. Maintenance
Date Service by Company Name Print Name Signature
Warranty Counter
Number
Service Record
Record any maintenance in the following table to assist in any warranty service.
WARNING!: Failure to maintain your door may
void the warranty on your door opener.
20.1 Door Maintenance
The door should be tested manually regularly to ensure it
is in good condition. A poorly maintained door could cause
fatal or serious injuries or serious damage to property.
Therefore it is recommended:
• Frequently examine the door, particularly the cables,
springs and mountings for signs of wear, damage or
imbalance. DO NOT USE if repair or adjustment is
needed since a fault in the installation or an incorrectly
balanced door may cause injury.
20.2 Lubrication (every 3 - 6 months)
To ensure a long and trouble free life for your door the
following is recommended:
• Guide Tracks: Clean the internal sections of the guide
tracks with a cloth dampened with mineral turps or
methylated spirits.
•
20.3 Door Service and Repair
If correct maintenance and servicing are not carried out,
warranty may be void. To keep your door running well, it is
recommended that your door be serviced by an experienced
technician, every 12 months or earlier if required:
• Lifting Cables (if fitted): Check for wear through rubbing.
If there is fraying or signs of corrosion contact your
dealer immeditately and discontinue use, leaving door
in the closed position.
• Fasterners: Check all screws, nuts and bolts to ensure
they are secure.
• Spring Tension: It is natural for springs to lose tension.
Should the door become hard to operate or completely
inoperative, contact your door professional
20.4 Opener Maintenance
To ensure a long and trouble free life for your opener the
following is recommended:
• Monthy: Run the test procedures in Section 12 to ensure
garage door is fit for use.
NOTE: If the door does not operate smoothly, call your
industrial door professional.
20.5 Service Indicator
As a reminder the GDO-10V3L2 Toro™ has a built in
maintenance counter. This counter has a factory default
of 60,000 cycles, and it is adjustable from 0 to 60,000
cycles. When this counter expires, at the start of each door
movement the beeper will sound three times and “SERVICE
DUE” message displays on the console.
At this time Automatic Technology recommends you contact
your industrial door professional to perform an annual door
service.
ELECTROCUTION! Disconnect the opener
power cord from the mains power before
making any door repairs / maintenance or
removing the opener button cover.
CAUTION: Door adjustments should only be
carried out by experienced persons, as this
function can be dangerous if not performed
under strict safety procedures
To Next Page
Loading...
