Autronica AutroVoice miniVES Series - Page 95

95
6
Audio Outputs / Name
The AutroVoice miniVES has 3 independent audio outputs. Double-clicking the name of the audio output enables to change
the genericname assigned by the congurator.
7
Audio Outputs / Connection
This tab displays the internal connection of a given audio output. Unlike the AutroVoice MULTIVES system these connections
are predened in the AutroVoice miniVES. The rst one being wired to the internal speaker, the second one is connected
to the internal 100 V bus through the amplier modules providing 100V signal to the line control cards and the third one is
a line output located on the AutroVoice miniVES charger module. The line output is not monitored by the system. The unit
treats the output line as a zone in the system (eg. signal to an independent PA system) to which it can transmit the message.
8
Audio Outputs / Pilot active
Selected Active Pilot option activates the control of the connection between audio output (DSP) and amplier module.
Thepilot signal is also used by the line control cards to supervise the speaker lines.
9
Audio Outputs / Feedback Destroyer
Activating Feedback Destroyer means that in places where the speakers are located in close proximity to the system
microphone, the eect of acoustic feedback will be signicantly limited.
q
Audio Outputs / Signal Processing
The window allows to change parameters like delay, volume level, limiter threshold and EQ. Setting the parameters
is possible in two ways:
1. by changing the values in a particular window Volume / Delay and uploading the conguration to the system;
2. by changing the parameters in the Volume / Delay section in on-line mode.
Outputs 2 and 3 of the AutroVoice miniVES Central Unit have an 8 band parametric equalizer which can be freely
congurable in two ways:
1. by changing the center frequency, lter quality and gain and uploading the conguration to the system;
2. by changing the parameters of the lters in on-line mode.