Chapter 6 --- Maintenance and Care of the QS12
56
N
ote
Clean and disinfect these accessories according to the lab regulations and transport them in a dry condition.
• Clean and disinfect the cryo chamber according to the lab regulations.
• Unscrew the handwheel handle for transportation.
N
ote
To make sure that there is no condensation water inside the chamber, let the instrument dry for approx 48 hours.
• Clean and disinfect the cryo chamber according to the lab regulations
• Arrange the dismounted accessories into the intended transportation packaging .
N
ote
Before the further transportation, tighten the fastening screws so that the instrument does not move during transportation.
•
Slightly tilt the QS12 and insert the foam parts underneath it.
• Place the case over the instrument.
• Insert the wooden cover.
• Attach the tightening stri
• Drain and rinse the water drain reservoir
ps around the packing.
Disposal of the instrument after final shutdown
After the nal shutdown of the instrument, we recommend to contact a local recycling
company for disposal according to the national applicable regulations.
To be applied in countries of the European Union and other European countries with a separate collecting
system within the waste management.
e marking of the product and/or the respective literature indicates that, after its nal shutdown, it must not be disposed of
together with ordinary domestic waste
• Please dispose of your instrument separately from other waste to prevent damage to the environment and/or
human health by uncontrolled waste disposal.
• Recycle your instrument to support the sustainable recycling of material resources.
• Industrial users should contact their suppliers and observe the conditions of the contract. is product must not
be disposed of together with other commercial waste.
• Please contact your supplier.
To Next Page