Chapter 6 --- Maintenance and Care of the QS12
55
Conditions for the transportation of the instrument
Returning the instrument for repair or routine Maintenance
Repair or maintenance work is normally carried out at the site of installation. If this is not possible for some special reason,
the instrument can be returned to manufacturer.
ss can be found at the beginning of this instruction manual.
• To guarantee trouble-free function of the instrument after transportation, please note the below-mentioned
measures for the transportation preparation.
• In addition, the conditions for storage and transportation as mentioned in part 1-2 must be observed during the
entire transportation.
N
ote the precautionary measures described in the safety precautions concerning biological hazards.
Measures for closing down:
• Turn
the instrument.
• Unplug the unit.
• Remove blade and/or knife from blade and/or knife carrier.
• Remove section waste trays, brush shelf, blade/knife carrier and other accessories as well as tools from the cryo
chamber.
Note
Clean and disinfect these accessories according to the lab regulations and transport them in dry condition.
• Clean and disinfect the cryo chamber according to lab regulations.
• Unscrew the handwheel handle for transportation.
• Before the transportation, thread up the xing bolts.
• Keep the heated sliding window closed during transportation.
N
ote
After reaching ambient te snemiceps noitces ot elba eb ot C°52--- ta rebmahc eht ni h 1 .xorppa sdeen redloh edalb eht ,erutarepm
again.
For transportation exterior, please observe the following measures:
• Turn
the instru
ment.
• Unplug the unit.
• Remove blade and/or knife from blade and/or knife
carrier.
• Remove section waste trays, brush shelf, blade/knife
carrier and other accessories as well as tools from the
cryo chamber.
To Next Page
Loading...