Administering options for the 9608, 9611G, 9621G, and 9641G SIP Deskphones
Issue 1 May 2011 111
USE_EXCHANGE_
CALENDAR
0 Flag, that indicates whether calendar data retrieval
from Exchange is selected or not. Values are: 0
(Disabled) or 1 (Enabled).
USE_QUAD_ZEROS_
FOR_HOLD
0 Flag that indicates whether a= directional
attributes or 0.0.0.0 IP Address is used in the SDP
to signal hold operation. 0=use “a= directional
attributes”, 1=use quad zeros.
VLANSEP 1 Enables or disables VLAN separation. Controls
whether frames received from the line interface
are forwarded to the phone or to the secondary
Ethernet interface based on VLANID. Also affects
whether frames received on the secondary
Ethernet interface are changed before forwarding
to the line interface. Values are: 1=On/Enabled, 0=
Off/Disabled. This parameter is used with several
related parameters. For more information, see
VLAN separation rules and related parameters
on
page 115.
VLANTEST 60 Number of seconds to wait for a DHCPOFFER
when using a non-zero VLAN ID (1-3 ASCII digits,
from “0” to “999”).
VU_MODE 0 Visiting User mode. Determines, if and how the
deskphone supports Visiting User capabilities:
0 = Off; the deskphone operates "normally" and
"Visiting User" has no essential impact for normal
operation.
1 = Optional; the deskphone prompts the user at
registration time if they are Visiting or Not.
2 = Forced; the deskphone only allows Visiting
User registrations.
VU_TIMER 36000 Idle time in seconds before the Visiting User
phone queries the user for re-registration. Valid
range is from 3600 - 86400 seconds.
WAIT_FOR_
REGISTRATION_TIMER
32 Time in seconds the SIP application will wait for a
register response message. If no message is
received, registration is retried. Range is 4-3600
(seconds).
WAIT_FOR_
UNREGISTRATION_
TIMER
32 Time the SIP application waits before declaring
un-registration to be complete. Under normal
circumstances un-registration includes termination
of all active SIP dialogs, and SIP registration.
Range is 4-3600 (seconds).
Parameter Name Default
Value
Description and Value Range
29 of 30
To Next Page
Loading...
