Figure 2: Connecting Avaya B189 Conference IP Phone to a wall LAN connector
The phone powers on.
Plugging in and resetting the deskphone using the Dynamic
Addressing Process
Note:
Before you start this process you must have an extension number for the IP deskphone and
the Communication Manager security code (password) for that extension, unless you intend
to use the deskphone with unnamed registration. For more information, see
About unnamed
registration on page 20. Any reference to the HTTP server applies equally to an HTTPS
server. You can run the plug in and reset process successfully using the following
description. If you see error messages, see
Chapter 5: Troubleshooting on page 39.
As the deskphone initializes, you see messages, some of which are part of DHCP process,
with a power on indication and dynamic feedback. These messages indicate that the phone is
active and not locked. You also receive useful information, about the status of the network, the
server, or the downloading operations, before the dial tone.
Installing the deskphone
14 Installing and maintaining Avaya B189 Conference IP Phone January 2014
Comments? infodev@avaya.com
To Next Page
Loading...
