Setting the operational mode to 802.1X
About this task
Use the following procedure to set or change the operational mode.
Procedure
1. When you select 802.1X from the Administrative Menu screen, the deskphone
displays the following:
802.1 Supplicant
Pass-thru
The options that are displayed depend on the following parameters as set in the
settings file:
• Disabled if DOT1XSTAT = 0
• Unicast-only if DOT1XSTAT = 1
• Unicast/multicast if DOT1XSTAT = 2
and the Pass-thru line is a text string associated with the current system value
of DOT1X where:
• Enabled mode if DOT1X = 0
• Enabled w/Logoff if DOT1X = 1
• Disabled if DOT1X = 2
2. Tap the line you want to change.
A green tick mark is set next to the option that you have selected.
3. To change the setting, tap the option again.
4. Tap Save to store the new setting and redisplay the Administrative Menu
screen.
Using the preinstallation checklist
Before performing static programming of address information, verify that the call system meets
all the requirements listed in the Requirements to verify for your network section of the Creating
the pre-installation checklist on page 11. You can skip item 4., as it refers to the DHCP server.
In addition, you must have the values for the following parameters. To prevent data entry errors
Using local Administrative Menu procedures
28 Installing and maintaining Avaya B189 Conference IP Phone January 2014
Comments? infodev@avaya.com
To Next Page
Loading...
