Avaya B189 - Performing a Self-Test

Procedure
1. Select SSON from the Administration Procedures screen.
The phone displays the current SSON value with a numeric keypad on the
screen.
2. To change the setting, use the Key pad on the screen to enter a valid SSON value
between 128 and 255.
3. Tap Save to store the new setting and redisplay the Administration Procedures
screen.
Performing a self-test
About this task
Note:
Avaya B189 Conference IP Phone stores two software code images in reprogrammable
non-volatile memory. The primary image, called the “big app” must be running to perform a
self-test. The backup image, called the “little app” does not support the self-test.
Use the following procedure to perform self-testing:
Procedure
1. Tap or select TEST from the Administration Procedures screen. The phone displays
the following text:
Press Test to confirm.
2. Tap or press Test to start phone testing.
Tap or press Cancel to return to the Administration Procedures screen without
testing the phone.
The test performs the following actions:
The screen glows red, green and blue color consecutively and plays the standard
ring tone with each color change.
The Mute microphone LED glows red, blue, and green alternately.
After approximately 5 seconds, the top phone screen displays either Self-test
passed or Self-test failed.
3. Press or tap Back to return to the Administration Menu screen.
Performing a self-test
Installing and maintaining Avaya B189 Conference IP Phone January 2014 37