To change the VLAN
ID value
Use the key pad on the screen to enter the new static
VLAN ID of from 0 to 4094, inclusive. Proceed to the next
step.
To change the
VLANTEST value
Use the key pad on the screen to enter the new value of
the DHCPOFFER wait period of from 0 to 999.
4. Tap Save to store the new setting and redisplay the Administration Menu screen or
Cancel to return to theAdministration Menu screen without saving the value
entered.
Once the new values are stored, the phone resets automatically.
Enabling and disabling the debug mode
Before you begin
If the default password is used, the setting associated with the serial port cannot be
changed.
About this task
You can use the debug mode to send all your debug data in a file, nnn_report.gz where you
replace nnn by the deskphone extension as specified by the user during registration.
Procedure
1. Access the Administration Procedures.
2. On the Administration Procedures screen, tap Debug.
The Debug procedures screen displays the following options:
Setting Status
Log Mode Off
Serial Port Off
Log to file Off
Phone Report
Note:
The Phone Report is always
available. If the URI is not present,
the report is stored on the phone
SSH Off
Enabling and disabling the debug mode
Installing and maintaining Avaya B189 Conference IP Phone January 2014 31
To Next Page
Loading...
