Avermedia AVerTV 6 - Editing or Removing Frequencies; Scanning Channels (for Advanced Users)

AVerTV 6
41
8. Click OK to exit the dialog box.
9. Select Programs under the Digital TV icon, and click Program Scan to obtain the
program data.
10. Click Apply to save the scanning results.
4.2.3 Editing or Removing Frequencies
You can edit or delete the undesired frequencies if the data is incorrect.
1. Select Digital TV.
2. Click Edit next to the satellite name where you want to edit frequencies. The Satellite
Information dialog box will appear.
3. Then choose one of the following actions:
To edit a single
frequency
Select the desired frequency. Change its
data, such as its frequency or FEC, and
then click Modify.
To delete a
single frequency
Select the frequency that you want to
remove, and click the Remove button
located on the lower-left corner.
To delete the
whole frequency
table
Click the Remove button located on the
upper-right corner.
4. Click OK to exit the dialog box.
4.2.4 Scanning Channels (For Advanced Users)
1. Click Advance located in the lower right corner of the Program Information section.
Then the Advance Program Configuration dialog box will appear.
2. When there are programs/frequencies missing from the program list, select Single
Frequency or Range Scan.
3. Specify the correct input port, polarization, frequency and symbol rate.
4. Click Scan.
5. After scanning, new active programs/frequencies will be memorized and listed on the
left pane of the dialog box.
6. Click OK to save the scanned results.
7. Click Apply to save the scanned channel.
Note: Range Scan may take you a while. Please be patient.