Avery Dennison ALS 350 - Adjust Pressure Roller at the Dispensing Edge43

43
3PRIOR TO OPERATING
3.3 MECHANICAL SETTINGS
ALS
350
450
3.3.2 Adjust pressure roller at the
dispensing edge
The pressure roller [33A] on the dispensing edge ena-
bles the label ribbon to run smoothly around the dis-
pensing edge and ensures that the labels separate
cleanly and in a controlled fashion from the backing
material.
The most favourable positioning of the pressure roller
unit may differ depending on the application.
For information on adjusting the pressure roller unit, the
customer service at our sales partner is at your dispos-
al.
Only if necessary:
£ Loosen the fastening screws [33B].
£ Adjust the pressure roller
£ Tighten the fastening screws.
[33] A Pressure roller unit
B Fastening screws
A
B