Avery Dennison ALS 350 - Position of Second Label (POS2); Position of Third Label (POS3)

68
4OPERATION
4.4 SETTINGS IN THE EXTENDED MENU
ALS
350
450
4.4.3 Position of second label
(POS2)
If the products are to be given two labels:
– Distance between the leading edges of the first and
second label [72A].
In the extended menu:
£ Call up the POS2 function.
£ Set the desired distance.
– Settings are possible in 0.1 mm steps:
minimum label length,
maximum 999.9 mm
– POS2 is not active if the value is set to 0.
£ Confirm the setting value using the ENTER key and
exit the function.
4.4.4 Position of third label (POS3)
If the products are to be given three labels:
– Distance between the leading edges of the second
and third label [73A].
In the extended menu:
£ Call up the POS3 function.
£ Set the desired distance.
– Settings are possible in 0.1 mm steps:
minimum label length,
maximum 999.9 mm
– POS3 is not active if the value is set to 0.
£ Confirm the setting value using the ENTER key and
exit the function.
[72] A Position of second label: Distance between the leading edges
of the first and second label
A
[73] A Position of third label: Distance between the leading edges of
the second and third label
A