Model E1070 Indicator User Instructions 49
Press the MODE key to scroll
through the activated applications.
The name of the active application
will be briefly displayed or, press
and hold the MODE key for 3-5
seconds to see the name of the
currently active application.
The E1070 comes equipped with several weighing applications;
• General weighing (default setting)
• Accumulator weighing
• Batch weighing
• Checkweighing
• Counting
• Peak weighing
These different applications are activated using a password protected menu.
Contact your local Avery Weigh-Tronix supplier or distributor for
assistance.
5.1 PLU Channels
This indicator has an 11 channel
PLU (Product Look Up) memory.
To access a memory channel,
press a number from 0 to 10, then
press the F1 key.
This indicator has an 11 channel PLU (Product Look Up) memory. To access
a memory channel, key in a number from 0 to 10, then press the F1 key. The
following information, if present, becomes active:
Channel #
ID #
Gross Accum.
Net Accum.
Count Accum.
Total
Tare Value
The general weighing application comes as the default application. You can
do gross weighments, tare/net weighments and print a print format. Below
are instructions for each.
5.2 Entering an ID Number
You can enter an ID number which is then part of the active PLU channel.
To enter an ID, key in a number on the keypad then press the ENTER key.
Indicator Operations
5
Lower Limit
Upper Limit
Piece Weight
Output Wt1
Output Wt2
Output Wt3
To Next Page
Loading...
Need help?
General
