78
Model E1070 Indicator Service Manual
16. Press the UNITS key. . .
EMAIL is displayed.
17. If you want the indicator to automatically send an email when an error
occurs, press the PRINT key to configure this. . .
ERR.LOG is displayed.
18. Press the PRINT key. . .
ON or OFF is displayed.
19. Use the UNITS or TARE key to toggle between ON and OFF. To send
an email when an overload or underload occurs on the scale, select ON.
Otherwise select OFF. Press either the PRINT or ENTER key to accept
your selection. . .
ERR.LOG is displayed.
20. Press the UNITS key. . .
S-COM is displayed.
21. Press the PRINT key. . .
ON or OFF is displayed.
22. Press UNITS or TARE to toggle between ON and OFF. If the indicator is
being connected to a SensorComm junction box and you want to send
an email when a SensorComm error occurs, select ON. Otherwise
select OFF. Press either the PRINT or ENTER key to accept your
selection. . .
S-COM is displayed.
23. Press the UNITS key. . .
GHOST is displayed.
24. Press the PRINT key. . .
ON or OFF is displayed.
25. If the indicator is being connected to a SensorComm junction box and
Ghosting is enabled and you want to send and email when a cell is
ghosted, select ON. Otherwise select OFF. Toggle to your choice and
press either the PRINT or ENTER key to accept your selection. . .
GHOST is displayed.
26. Press the SELECT key, then the UNITS key….
ProtcL is displayed.
Service Menu—OPTION submenu (continued)
To Next Page
Loading...
