90
Model E1070 Indicator Service Manual
19. Press the PRINT key. . .
1 is displayed. This stands for Setpoint 1.
20. Scroll through the choices with the TARE or UNITS key. Press ENTER
when your choice is displayed. . .
SETPT is displayed.
If you chose 1 this ingredient will use output #1. The same is true
for the 2 and 3 choices. If you choose NONE, no output will be
activated when the ingredient is called by the recipe.
21. Press the UNITS key. . .
DELAY is displayed.
22. Press the PRINT key. . .
The current delay value in seconds is displayed.
23. Accept this value by pressing ENTER or key in a new value and press
ENTER. . .
DELAY is displayed. Repeat steps 19 through 28 for all the
ingredients in your recipe.
24. Press the SELECT key twice. . .
RECIPE is displayed.
25. Press the UNITS key. . .
MODE is displayed. Use this item to set the mode of the batching
application to Automatic, Manual or Fill.
AUTO - In auto mode, after the user begins the batching process
the indicator will activate the OP2 output when the weight for OP1
has been reached. When the weight for OP2 is reached, OP3 will
activate. This happens with no intervention from the operator.
MAN. - In manual mode, after the user begins the batching
process, the user must press the F1 key to activate each subse-
quent output after each output weight is reached.
FILL - In FILL mode, any recipe that has been setup is ignored.
The filling process is run based on the values set for the cutoffs.
In order to complete the filling process, at least one cutoff must be
enabled.
CONT - Continuous batching mode. This mode is very close to
the Auto mode, but in continuous mode, another batch is started
immediately after the previous batch has finished. In Auto mode,
the user must press the F1 key to start each batch.
26. Press the PRINT key. . .
The current mode setting is displayed.
27 . Toggle between the choices by pressing the TARE or UNITS key. Press
the ENTER key when your choice is displayed. . .
MODE is displayed.
Supervisor Menu—(continued)
To Next Page
Loading...
