94
Model E1070 Indicator Service Manual
Count Application 1. From previous step 12, press the UNITS key. . .
COUNT is displayed. Use this item to clear and print reports for
the count application.
2. Press the PRINT key. . .
PRINT is displayed. Use this item to print out a complete report of
count application information.
3. Press the PRINT key . . .
Port 1 or PORT 2 is displayed. Use this item to select which port
to use for printing the report.
4. Toggle between PORT 1 and PORT 2 using the TARE or UNITS key.
Press the ENTER key when the choice you want is displayed. . .
Display shows BUSY briefly then returns to PRINT.
5. Press the UNITS key. . .
MIN is displayed. Use this item to set the minimum sample weight
as a percent of capacity.
6. Press the PRINT key. . .
Current value is displayed.
7. Key in a percentage from 0-100% and press ENTER. . .
MIN is displayed.
8. Press the UNITS key. . .
SIZE is displayed. This is the sample size parameter. Use this to
set the sample size for the counting application.
9. Press the PRINT key. . .
Current sample size is displayed.
10. Key in a new sample size. Press ENTER to accept. . .
SIZE is displayed.
Supervisor Menu—(continued)
To Next Page
Loading...
